Hi,
I'm trying to configure a Quantum PLC to connect with an Avantys Remote IO island over Ethernet using Proworx32.
I've watched the video tutorial on the tele website but they're using the concept software.
I've setup the NOE card and have it communicating with a SCADA PC. The bit I'm stuck on is the IO addressing. Do I use the peer cop wizard or the IO scanner wizard?
Also once I've configured the IO how do i use it in the program, e.g how do I reference a bit a register?
Any help would be appreciated
Thanks in advance
Rich
I'm trying to configure a Quantum PLC to connect with an Avantys Remote IO island over Ethernet using Proworx32.
I've watched the video tutorial on the tele website but they're using the concept software.
I've setup the NOE card and have it communicating with a SCADA PC. The bit I'm stuck on is the IO addressing. Do I use the peer cop wizard or the IO scanner wizard?
Also once I've configured the IO how do i use it in the program, e.g how do I reference a bit a register?
Any help would be appreciated
Thanks in advance
Rich