cottagewood
Member
I'm struggling to get a stepper motor working. I have it working in inch mode and I can reference the drive and get the sync bit on.
When I change the mode to 6, I write the MDI block (which I assume is the data area DBB176 - DBB195) I get a syntax error.
I have only set Data in
DBB180 DBD184 and DBD186 as in the example project but I'm wondering if I need to set any thing in DBB196 -DB199?
The same thing occurs with bit dbx14.1 set on ( test mode).
Thanks
Andy
When I change the mode to 6, I write the MDI block (which I assume is the data area DBB176 - DBB195) I get a syntax error.
I have only set Data in
DBB180 DBD184 and DBD186 as in the example project but I'm wondering if I need to set any thing in DBB196 -DB199?
The same thing occurs with bit dbx14.1 set on ( test mode).
Thanks
Andy