Mas01
Member
A particular T/C module was only using ch2. I updated it to also use ch1 and ch3 (1st and 3rd channel). I don't even know what D114.1 means but I just guessed I needed a D114.0 and a D114.2, so I added the two legs into the code. Now, the thermocouples on ch1 and ch3 are showing good values when I inject a temperature, but D114.0 and D114.2 are shown in blue (I'm using monitor mode to show values of registers). Why are they blue but D114.1 is not blue?
For info g49 is for error detection on the thermocouple module. Thanks
For info g49 is for error detection on the thermocouple module. Thanks
Last edited: