cockrell960
Member
I am trying to get a contrologix l62 to message a micro820 using the serial connection through a mds 9810. I am not having luck. There are multiple nodes on the serial network and I believe that is my issue since the mds 9810 runs half duplex but the serial on the micro820 runs full duplex. What gets me is that you can set a node number on the micro820 which would make me think it can perform at half duplex.
I am using a cip data table read pointing to the correct node.
We previously had a micro1200 which did half duplex.
Is there any way to make it work??
Thank you
I am using a cip data table read pointing to the correct node.
We previously had a micro1200 which did half duplex.
Is there any way to make it work??
Thank you