Hi guys,
I'm neck deep in other projects so I don't have the time to do the full research at the moment.
I have a machine running a micrologix 1000 and recently had a prox sensor start detecting things further out then it should. Normally it looks out about 1" and started looking out about 6".
I replaced the sensor which worked correctly for about 2 weeks then it started looking out to far like the first one did. For the time being I've just done the electrical tape diffuser hack.
When I check the dc output from the plc I'm only getting 22 volts instead of the expected 24.
Could this be why I'm having problems?
Can I just fix that bit of it or are these disposable units?
Any help would be appreciated, thanks fellers.
I'm neck deep in other projects so I don't have the time to do the full research at the moment.
I have a machine running a micrologix 1000 and recently had a prox sensor start detecting things further out then it should. Normally it looks out about 1" and started looking out about 6".
I replaced the sensor which worked correctly for about 2 weeks then it started looking out to far like the first one did. For the time being I've just done the electrical tape diffuser hack.
When I check the dc output from the plc I'm only getting 22 volts instead of the expected 24.
Could this be why I'm having problems?
Can I just fix that bit of it or are these disposable units?
Any help would be appreciated, thanks fellers.