ML1400 to Banner VE Camera messaging
- Thread starter wilkerson29847
- Start date
wilkerson29847
Member
OP
What was not included in the manual or instructions on doing a product change is that you had to trigger the camera before you could read the new inspection number in the camera. I had to get online with a Banner Applications Engineer to get this tidbit of information.
drbitboy
Lifetime Supporting Member
Typical.
Thanks for providing the follow-up.
Thanks for providing the follow-up.
Similar Topics
Hello,
I am new here and have been working with PLCs for a few years now. I have been tasked with setting up a Micrologix 1400….. to a Cmore 10...
Hi,
We may of finally received out first v21 ML1400.
IP address set, proceed to download standard file for our machines & at about the 80% mark...
I have a Allen Bradely 1500 that has a cracked board. It still works but needs replaced (battery is no longer connected). To make migration easier...
Hi,
I've got a new project for a vacuum conveying system. We require to add another HMI to the existing system which will then feed 2 separate...
Hi All
I have connected a Keyence SR1000 to a Compact Logix PLC and am triggering the scanner and reading barcodes over Ethernet/IP, no issues...
