can anybody help me?
i have a Omron C200HS and a NT631C screen i have no idea how to get them to run together.
i am new to omron how do i set them up to run together?
cheers
the PLC is a C200HS CPU 21
the screen is NT631C-ST151-E
i am just testing at the moment so the cable length isn't a problem
it has the RS232C port but i don't know what settings i need to change to get them to communicated properly
i've got them connected up. the screen is initialised and goes into run mod and all i get is a black screen. when i access the terminal it has all the screen data on there. i downloaded it to the laptop and everything is there. the only thing im unsure about my set-up is the control/notify area settings
i have the PT Control Area set to PLC Address D00200
i have the PT Notify Area set to PLC Address D00210
this is the bit i'm unsure about
i have got the initial screen set to screen 1
in the I/O comments in CX-Programmer in the Area Type the addresses are DM and not D will this be causeing issues?
is there anyway to check this and stop it?
that has loaded up straight away, it is working and firing the outputs
what was that rung for? is it to tell the PLC where to find the screen?