Jinto
Member
Hi, I need a little help with something that will probably be very easy and obvious to anybody who uses the Omron PLCs with Syswin.
I usually work with Rockwell equipment but have been asked by a customer to put a small mod into an Omron C200HS which I have never worked on before. I have managed to borrow a laptop which is loaded with Syswin 3.4 and I have a PLC lead. I managed to get connected and uploaded the program from the PLC but when I try to select online editing, it does a check on the program and brings up a “missing End” message although when I look at the uploaded program I can see an end statement followed by some NOP instructions.
It is a fairly short program which seems to be using just one block.
Can somebody please point out the blindingly obvious mistake I’m making, I have looked at the syswin manual but didn’t find the answer.
I usually work with Rockwell equipment but have been asked by a customer to put a small mod into an Omron C200HS which I have never worked on before. I have managed to borrow a laptop which is loaded with Syswin 3.4 and I have a PLC lead. I managed to get connected and uploaded the program from the PLC but when I try to select online editing, it does a check on the program and brings up a “missing End” message although when I look at the uploaded program I can see an end statement followed by some NOP instructions.
It is a fairly short program which seems to be using just one block.
Can somebody please point out the blindingly obvious mistake I’m making, I have looked at the syswin manual but didn’t find the answer.