Omron MAD42 Set Up

[MitsM83]

I have little to no experience with Omron. A co-worker is trying to set up a MAD42 Analog I/0 card with a CJ1M CPU 11 on a little trainer unit. He wants to bring in a Pot value and display it on a 7 segment display. I was asked to help. It is in "slot" 2. The input is working. Using input 2 and output 2. I am getting the pot value into CIO2005 and using a MOV command to CIO2002 but I get no voltage to the Output. What am I doing wrong? Even if I force a value into that word I get no output.

 

[gclshortt]

http://www.omronkft.hu/nostree/pdfs/sysmac/w490-e1-03.pdf

6-7 Analog Output Functions and Operating Procedures
The above section of the manual will take you through a series of steps to enable and set the range of the analog outputs.

Hope this helps you out.
Regards,

 

[MitsM83]

So it points to a piece of software called Sysmac Studio to set up the variable table. Then the manual explains set up with this table. Is there a way to set it up without this software? I have tries using the settings if you right click on it where you set up your rack and go to Unti Setup with no luck. I feel like I am missing something that would be included in the variable table.

Or a list of the D20000 range, like what each bit is.. I could count from the variable table in the manual I suppose but might take a while.


Thanks,

 

[gclshortt]

https://www.fa.omron.com.cn/data_pdf/mnu/w345-e1-12_cj1w-ad_da_mad.pdf?id=31

Sorry I gave you the wrong reference manual. The above one is for the CJ-series Analog I/O Unit (CJ1W-MAD42).
Look at Section 9.

Regards,

 

[MitsM83]

I was able to get her going with this.

Thanks

 

[gclshortt]

Good to hear!

Thanks for the update.