coopdegrace
Member
Hi All,
Just wanted to get your opinion on an issue we are having with a PanelView Plus 600.
CAT: 2711P-T6C20D8 SER A
After a period of time (few minutes or so) the screen will go blank but still illuminated and show only the cursor. Pressing the screen does not return it to its run time. Operators on site need to power cycle the screen to return to run-time.
Just wondering if anyone has seen/experienced this same issue and may have some suggestions.
I have not reloaded the run-time or updated firmware, just wanted opinions before taking the next step as I will have to travel to site to do this.
Cheers
Just wanted to get your opinion on an issue we are having with a PanelView Plus 600.
CAT: 2711P-T6C20D8 SER A
After a period of time (few minutes or so) the screen will go blank but still illuminated and show only the cursor. Pressing the screen does not return it to its run time. Operators on site need to power cycle the screen to return to run-time.
Just wondering if anyone has seen/experienced this same issue and may have some suggestions.
I have not reloaded the run-time or updated firmware, just wanted opinions before taking the next step as I will have to travel to site to do this.
Cheers