Hello all,
I know I have asked questions on this before, but does anyone have insight as to why discrete I/O would work on some screens but not on others post conversion from PLC-5 to Control Logix? My panel I/O is set up through a buffer routine, but when I go to impute numeric values into registers I get a Mistake Pop up saying "PLC did not acknowledge Enter Bit.", as well if I go to the integer register for the same numeric value in the PLC and change in there it does register on the screen. Could I have missed a I/O mask on this?
Best regards,
Frederick
I know I have asked questions on this before, but does anyone have insight as to why discrete I/O would work on some screens but not on others post conversion from PLC-5 to Control Logix? My panel I/O is set up through a buffer routine, but when I go to impute numeric values into registers I get a Mistake Pop up saying "PLC did not acknowledge Enter Bit.", as well if I go to the integer register for the same numeric value in the PLC and change in there it does register on the screen. Could I have missed a I/O mask on this?
Best regards,
Frederick