Kipper
Member
I read that you can down load PCIS from Allen Bradley for free. Its software for a SLC 100 150 PLC?
Does any one know where to go to get it?
Thanks Kipp
Does any one know where to go to get it?
Thanks Kipp
Pcis
- Thread starter Kipper
- Start date
geniusintraining
Lifetime Supporting Member + Moderator
Send me a email and I will look it up, I think I have it also on my site... [email protected]
I think you can also search this site and find the link...
I think you can also search this site and find the link...
FactoryTalktotheHand
Member
I'd use the link from this site as opposed to A-B. I couldn't get Rockwell's version to install.
Since you are new to the site here is the link:
http://www.plctalk.net/qanda/misc.php?do=showattachments&t=28751
http://www.plctalk.net/qanda/misc.php?do=showattachments&t=28751
Similar Topics
I have the PCIS software on a windows 7 64 bit laptop. In my experience with other DOS based software they will not work in DOSBOX on a 64 bit...
We have an old machine that has a SLC 150 in it and it went down with a fault today of no program.
We have the pcis software on an old windows 95...
Hello All,
I am attempting to upload from a SLC 100. I know the controller is good because it is still in operation. I know the programming port...
Hello
i have finally got dosbox and pcis working properly and communicating with the slc. Dosbox did not like the usb to serial convertor i was...
Hello Gentlemen (and Ladies),
I have a SLC150 I am playing with. It's baud rate is 9600. Easy to establish comm with it using a 1745-PCC...