Hi. I'm struggling with configuration of PN-PN coupler 6ES7 158-3AD10-0XA0.
The situation is as follows:
I have 1 S7-300 PLC on the X2 part of the coupler, and 4 s7-300 PLCs on the X1.
I need to communicate those 4 to exchange data with that one. I'm using classic step 7 5.6.
According to manual - it's possible using shared device.
https://imgur.com/a/5YaXwDx
My problem is, I cannot find any example concerning classic Step7, only TIA.
Second problem is - The X2 side of the coupler is in another project - done in TIA.
So I have X1 side of the coupler in Step7 project the X2 in different one - is it possible to connect that way or I will encounter problems?
Have You done this before, can You share some light ?
Best regards.
The situation is as follows:
I have 1 S7-300 PLC on the X2 part of the coupler, and 4 s7-300 PLCs on the X1.
I need to communicate those 4 to exchange data with that one. I'm using classic step 7 5.6.
According to manual - it's possible using shared device.
https://imgur.com/a/5YaXwDx
My problem is, I cannot find any example concerning classic Step7, only TIA.
Second problem is - The X2 side of the coupler is in another project - done in TIA.
So I have X1 side of the coupler in Step7 project the X2 in different one - is it possible to connect that way or I will encounter problems?
Have You done this before, can You share some light ?
Best regards.