Ones_Zeros
Member
Hello,
I have a Allen Bradley SMC Dialog Plus that i communicate to through a Scanport 1203-EN1 and i'm getting this error below
I/O Faulted
Code 16#0100 (Connection Request Error: Module in Use
How do I remove this error/fault?
In the image above, The SMC Dialog Plus has a "yellow explanation mark" beside it in the PLC tree. I have the correct IP address assign to both the scan port and the configuration in the PLC
I can ping the scanport IP but the PLC doesnt seem to be communicating to it
I appreciate your help
I have a Allen Bradley SMC Dialog Plus that i communicate to through a Scanport 1203-EN1 and i'm getting this error below
I/O Faulted
Code 16#0100 (Connection Request Error: Module in Use
How do I remove this error/fault?
In the image above, The SMC Dialog Plus has a "yellow explanation mark" beside it in the PLC tree. I have the correct IP address assign to both the scan port and the configuration in the PLC
I can ping the scanport IP but the PLC doesnt seem to be communicating to it
I appreciate your help