I use the HMI simulation as our production lines are pretty big and we've put an upgrade in over the last couple of months and I've used it most days.
I've had a couple of weeks off and when I've tried to use it again it won't open up. I use Ctrl, Shift + X to start it and when I do that it starts the compile and pops up the warning message saying it will start on this page, but the the RT just doesn't appear. There are no errors or messages and as far as I'm aware nobody has touched it in my absence.
Has anyone had this before and/or any suggestions? Using v15.
I've had a couple of weeks off and when I've tried to use it again it won't open up. I use Ctrl, Shift + X to start it and when I do that it starts the compile and pops up the warning message saying it will start on this page, but the the RT just doesn't appear. There are no errors or messages and as far as I'm aware nobody has touched it in my absence.
Has anyone had this before and/or any suggestions? Using v15.