Hi all,
I get this message when I try to upload a V10.5 program using V11. "The block main cannot be opened because it was created with TIA portal V10.5"
FYI: The steps I have made to encounter the error are as follows:
Cheers, Nathan
I get this message when I try to upload a V10.5 program using V11. "The block main cannot be opened because it was created with TIA portal V10.5"
FYI: The steps I have made to encounter the error are as follows:
- Create a new project in V11 basic and select an unspecified CPU as the PLC
- Connect S7-1200CPU to my network card on my PC (CPU is firmware V1.0 and has a working V10.5 program in memory)
- Detect hardware configuration for the unspecified CPU
- Compiled project
- Saved new project to disk ( I have tried without steps 4 and 5 as well)
- Update accessible devices connected to my network card
- Right click accessible device “Program blocks” folder and select copy
- Right click the new project “program blocks” folder I created in step 1 and select paste
- I receive the error message the block “Main OB1 cannot be opened because it was created with TIA portal V10.5”
Cheers, Nathan