Yaskawa Ecam Help

JOHN ARMSTRONG

Member
J
Join Date
Jun 2005
Posts
11
Could anyone be of assistance in testing or reviewing some YTERM code for the ECAM function on a SMC-4040 Yaskawa controller? I am experiencing a erroneous commanded position at the end of the cam profile, that so far tuning has not eliminated. I would be happy to post or email the program. Thanks - John
 

Similar Topics

B
Extract time from Yaskawa registers in Studio 5000
What is the best way to extract the hour and minute from the register that comes from Yaskawa VFD. In studio 5000 I have a register saved as INT...
Replies
3
Views
132
Bart_PSI
B
V
Yaskawa GL60s PLC
Hi sir I has a equipment use Yaskawa GL60s PLC via P150 developer,we want to upgreat the system to New,but we have some problems For example: On...
Replies
0
Views
151
van83619
V
E
YASKAWA Control
Hi Everybody, this may be one for you motion control guys. We have been tasked with interfacing some Yaskawa drives into a project where the...
Replies
0
Views
273
exiled
E
N
Yaskawa GA800 VFD bUS [Option Communication Error]
Hello, We have several Yaskawa GA800's installed in our plant. They are all controlled via Ethernet and they work fine. However, they all get...
Replies
0
Views
489
NGCPLC
N
R
Beckhoff IPC with Yaskawa drive MC_HOME not working
Hi Everyone, I have a project involving a Beckhoff IPC with Twincat and a Yaskawa servo motor and drive. I'm trying to use the MC_HOME function...
Replies
2
Views
512
Zensequitur
Zensequitur
Back
Top Bottom