Siemens s7 300 and yasakawa A1000 pid parallel operation

Hasitha

Member
H
Join Date
Dec 2015
Location
colombo
Posts
44
Can any one help me regarding how to give set point via field bus for control yasakawa a1000 drive while it is running on PID operation.
Also i wanna know what is the control word that i should trnsfer to specific bit??
Help me guys
 

Similar Topics

ceilingwalker
ESA HMI and Siemens S7-300 question
Hello all. I have an ESA HMI that is connected to a Simatic S7-300 (CPU312). I have uploaded the program from the PLC which is written with Step7...
Replies
6
Views
1,447
ceilingwalker
ceilingwalker
M
Siemens S7 300 PLC replacement issue
Hello. There is a problem with Siemens S7 300. We got a replacement PLC but it does not run the program from the MMC. The new PLC is dated 2011...
Replies
3
Views
689
Rob...
R
M
Help with IP address on a Siemens Simatic S7300
Hi to all, Our company does not usually use Siemens PLCs, but have a press with one in it. We are trying to change the IP address in our Simatic...
Replies
2
Views
1,066
Maintenance Man
M
A
Siemens S7-300 not going into run mode
G'day guys, I am setting up a s7-300 as a test rig for the workshop and when I downloaded the PLC is not going into run mode, I keep getting a...
2 3
Replies
35
Views
5,222
advanced.eic
A
J
Write MSEC to S7 300 Siemens Controller
I am trying to write just MSEC to S7 300 Controller date/time using OI.SIDIRECT Aveva communication driver? The old HMI (WINCC) tag is assigned...
Replies
1
Views
1,059
Lare
L
Back
Top Bottom