Shawn Van Gundy
Member
I'm having an issue using the supplied PF52XUSB file to flash my programs. I was able to use it to flash the control section of my 525 drives when I had Windows 7 installed.
My company had us upgrade our machines to Windows 10 and since then I haven't been able to get the flash to finish. It starts to flash and gets to around 25-40 blocks before stopping any movement for up to 30 minutes. It never recovers.
I've tried running the program as Admin and running it in compatibility mode down to Windows XP with no luck.
Has anyone else experienced this issue before? If so, how did you fix it? I'm pretty much at my wit's end here. any help would be appreciated.
My company had us upgrade our machines to Windows 10 and since then I haven't been able to get the flash to finish. It starts to flash and gets to around 25-40 blocks before stopping any movement for up to 30 minutes. It never recovers.
I've tried running the program as Admin and running it in compatibility mode down to Windows XP with no luck.
Has anyone else experienced this issue before? If so, how did you fix it? I'm pretty much at my wit's end here. any help would be appreciated.