PLCrookiee
Member
Hi guys, I have just recently purchased a 1734-AENTR module so that I could learn how to configure it through LogixDesigner and establish comms etc.
I am getting a flashing red light for ‘Point Bus Status’ and a module fault code of “16#0010” I have ensured that the chassis size is set to ‘1’ as I do not have any expansion cards yet, I have also power cycled multiple times but still nothing has worked.
I have also tried using the web interface but it doesnÂ’t seem to display the chassis size on there for me to confirm. I can ping the module from my laptop though.
I am starting to think that maybe you need at least one card added to the module in order for the Point Bus Status to come good. Can anyone clarify this
I am getting a flashing red light for ‘Point Bus Status’ and a module fault code of “16#0010” I have ensured that the chassis size is set to ‘1’ as I do not have any expansion cards yet, I have also power cycled multiple times but still nothing has worked.
I have also tried using the web interface but it doesnÂ’t seem to display the chassis size on there for me to confirm. I can ping the module from my laptop though.
I am starting to think that maybe you need at least one card added to the module in order for the Point Bus Status to come good. Can anyone clarify this