Hey all... looking for some advice.
SLC 5/05 - the hope is to gradually phase logic and I/O over to a 1769-L27ERM using the existing SLC I/O (for now) as an I/O rack. There are a couple SLC specialty cards that I'm reading are NOT compatible - a 1747-SN card, and a 1747-SDN card.
Not too worried about the D-Net card, but the RIO scanner is talking to a few Fanuc RJ1 Robots and those comms are not upgradable. Am I dead in the water with this solution? Is there another option? The issue is timing... we will only have a few hours here or there to work on running/testing the new program, then we would revert back to the SLC 5/05 to run production.
Thanks,
4
SLC 5/05 - the hope is to gradually phase logic and I/O over to a 1769-L27ERM using the existing SLC I/O (for now) as an I/O rack. There are a couple SLC specialty cards that I'm reading are NOT compatible - a 1747-SN card, and a 1747-SDN card.
Not too worried about the D-Net card, but the RIO scanner is talking to a few Fanuc RJ1 Robots and those comms are not upgradable. Am I dead in the water with this solution? Is there another option? The issue is timing... we will only have a few hours here or there to work on running/testing the new program, then we would revert back to the SLC 5/05 to run production.
Thanks,
4