Hello everyone,
I have a problem with a system consisting of a Eaton XV-100 panel and a Easy 800PLC.
The first XV-100 broke down, and it was replaced by a second one with the same program.
However once the new XV-100 was installed i get no response and sometimes an error flashes:
<48> Communication disturbed: message 'arry' @ M1, SYSTEM PORT, Moeller EasyCom - Fatal
Could this be a baud rate issue?
If so, is it possible to change the baud rate on the display it self, as it is now installed in a remote location where i can only provide phone support.
Thanks,
I have a problem with a system consisting of a Eaton XV-100 panel and a Easy 800PLC.
The first XV-100 broke down, and it was replaced by a second one with the same program.
However once the new XV-100 was installed i get no response and sometimes an error flashes:
<48> Communication disturbed: message 'arry' @ M1, SYSTEM PORT, Moeller EasyCom - Fatal
Could this be a baud rate issue?
If so, is it possible to change the baud rate on the display it self, as it is now installed in a remote location where i can only provide phone support.
Thanks,