I am facing a problem in which when the emergency stop is pressed, the motor comes to zero speed but going to start state instead of stop state.
i have attached he wiring diagram.
"previous" file consist of my current wiring diagram!
"latest" file corresponds to correction that i would like to do. Is it correct approach?
Please correct me if the following statement is correct.
pin 18 - if low signal is given then stop command is enabled!
pin 17- if high signal is given then start command is enabled!
am i right?
i have attached he wiring diagram.
"previous" file consist of my current wiring diagram!
"latest" file corresponds to correction that i would like to do. Is it correct approach?
Please correct me if the following statement is correct.
pin 18 - if low signal is given then stop command is enabled!
pin 17- if high signal is given then start command is enabled!
am i right?