scottmurphy
Member
- Join Date
- Oct 2004
- Posts
- 363
Hi All,
I have a Magelis XBT-RT511 configured as a Modbus slave from a RTU.
I am reading setpoints from the XBT into the RTU fine, bit if there is a loss of comms, the XBT resets its values, hence resetting the setpoints!!
Is there a way to prevent this happening within the XBT? These are pretty basic units.
I know I couild do some code to write the SP back after comms failure or if = 0 etc, just want to rule out the easiest option first!
Scott
I have a Magelis XBT-RT511 configured as a Modbus slave from a RTU.
I am reading setpoints from the XBT into the RTU fine, bit if there is a loss of comms, the XBT resets its values, hence resetting the setpoints!!
Is there a way to prevent this happening within the XBT? These are pretty basic units.
I know I couild do some code to write the SP back after comms failure or if = 0 etc, just want to rule out the easiest option first!
Scott