I'm trying to Extract the database from a Red Lion G310C HMI, connected to a FX3U Mitsubishi PLC. It has the Support UpLoad enabled. I tried USB (it says starting firmware and then it fails:ERROR no reply from remote device)even though I installed the USB driver from Crimson and RS-232 Port, but it didn't work. I'm using the Ethernet port, with a regular computer network cable. I know the Ethernet port configuration:
Port Mode: Manual Configuration
IP Address: 10.0.0.100, Network Mask: 255.0.0.0, Gateway:0.0.0.0
IP Routing: Disabled
Physical Layer: Enable Full Duplex, Enable High Speed (both checked)
Maximum Segment Size. For Send:1280, For Receive: 1280
Remote Update. IP Download: Enabled, Port Number: 789
My computer has the following IP Address: 10.0.0.101, Network Mask:255.0.0.0
Do I have to use a crossover cable? Any clue why it keeps saying that it can't open the port?
Port Mode: Manual Configuration
IP Address: 10.0.0.100, Network Mask: 255.0.0.0, Gateway:0.0.0.0
IP Routing: Disabled
Physical Layer: Enable Full Duplex, Enable High Speed (both checked)
Maximum Segment Size. For Send:1280, For Receive: 1280
Remote Update. IP Download: Enabled, Port Number: 789
My computer has the following IP Address: 10.0.0.101, Network Mask:255.0.0.0
Do I have to use a crossover cable? Any clue why it keeps saying that it can't open the port?