KorhanGencer
Member
Hey all,
I am using Vijeo Designer v6.2.8.12 for a mineral plant project. For that, I needed to incorporate three different plants' HMI page in order to make them found in one project/target for one HMI panel.
Thus, I have created a new driver using "MODBUS TCP IP" under "IO Manager" section found in the left part of Vijeo Designer and added three different CPU addresses under that as three different IO equipments.
Ex: MODBUSTCPIP02
AD [XXX.XXX.X.XXX]
D2 [XXX.XXX.X.XXX]
PA [XXX.XXX.X.XXX]
Moreover, I have imported the variables/tags required from Unity Pro as a .xvm file.
Ex: PLC_AD
PLC_AD.A01.QErrVFD
...
...
Everything seemed very neat until I have finished required works here and built the project and went online. For PLC_PA, I am getting the data correctly and without any major problems. But the data comes with an approximately 10-15 seconds delay and this delay warns me with yellow exclamation mark.
When it comes to PLC_AD and PLC_D2; I am getting these errors:
"PLC returned error code. FDH - C1C0H (AD)"
"PLC returned error code. FDH - C1C0H (D2)"
When I google this error code, this link comes:
https://www.se.com/ww/en/faqs/FA234...or usually,application just before a download.
I have updated the .xvm file and done the resolution steps but no such luck. Suggestions or any different sources for solution for these problems?
Thank you in advance,
Korhan
I am using Vijeo Designer v6.2.8.12 for a mineral plant project. For that, I needed to incorporate three different plants' HMI page in order to make them found in one project/target for one HMI panel.
Thus, I have created a new driver using "MODBUS TCP IP" under "IO Manager" section found in the left part of Vijeo Designer and added three different CPU addresses under that as three different IO equipments.
Ex: MODBUSTCPIP02
AD [XXX.XXX.X.XXX]
D2 [XXX.XXX.X.XXX]
PA [XXX.XXX.X.XXX]
Moreover, I have imported the variables/tags required from Unity Pro as a .xvm file.
Ex: PLC_AD
PLC_AD.A01.QErrVFD
...
...
Everything seemed very neat until I have finished required works here and built the project and went online. For PLC_PA, I am getting the data correctly and without any major problems. But the data comes with an approximately 10-15 seconds delay and this delay warns me with yellow exclamation mark.
When it comes to PLC_AD and PLC_D2; I am getting these errors:
"PLC returned error code. FDH - C1C0H (AD)"
"PLC returned error code. FDH - C1C0H (D2)"
When I google this error code, this link comes:
https://www.se.com/ww/en/faqs/FA234...or usually,application just before a download.
I have updated the .xvm file and done the resolution steps but no such luck. Suggestions or any different sources for solution for these problems?
Thank you in advance,
Korhan
Last edited: