alive15
Member
Good afternoon to all,
I have a machine that sends a 24 VDC signal out after cycle complete. This signal goes to the robot digitial I/O module. However the signal only stays on for 2 seconds. The robot may or may not be waiting to see the signal, so I need a way to maintain this 24 V.
Unfortunately, the program from the machine does not allow for the 24 V to be latched in. There is no PLC controlling it either.
Is there a device out there that acts similar to the latch instruction like OTL from RS Logix?
Thanks, please let me know if any more information is required.
I have a machine that sends a 24 VDC signal out after cycle complete. This signal goes to the robot digitial I/O module. However the signal only stays on for 2 seconds. The robot may or may not be waiting to see the signal, so I need a way to maintain this 24 V.
Unfortunately, the program from the machine does not allow for the 24 V to be latched in. There is no PLC controlling it either.
Is there a device out there that acts similar to the latch instruction like OTL from RS Logix?
Thanks, please let me know if any more information is required.