Changing MAC Address 1756-ENBT

When all else fails, the MAC address is available, and sometimes is used to configure the IP of a card. You don't want them changed on a process system; it's like the Golden Rule of the secret internet society. Most people don't even know about MAC, let alone try to change it.

If you're using a BOOTP configuration, change the IP in the BOOTP server for the proper MAC address, NOT at the module (which you can't!).
 

Similar Topics

M
Changing a PowerFlex 525.
Hi to all. We need to change a bad powerFlex 525 to a new one. How do you save the configuration to install in the new one? Thank you all for...
Replies
5
Views
236
James Mcquade
J
F
HMI Buttons go to error after changing screens
Hi all, I am having an issue where some of my HMI push Buttons and Indicators go in to error when I navigate to a new screen. I am using a...
2
Replies
16
Views
471
plvlce
P
M
AB Armor block signal lag not changing state.
We have a new machine that uses an armor block to transfer input signals for conveyor position that continuously alarms out on no position change...
Replies
0
Views
90
Mgw1970
M
D
Changing OMRON PLC & HMI IP causing communication break
Hello everyone, I am trying to change the IP address of the Omron PLC (NJ30-1200) and HMI (NB7W-TW01B) to fetch the network on our network...
Replies
7
Views
289
Dshahzad
D
M
GEO SCADA Changing the Alarm Limit Values on MIMIC by users
Dear Experts, I'm just started working with GEO SCADA and I need your valuable help. Currently, I'm trying to edit the alarm limits on MIMIC...
Replies
0
Views
214
mahmoud shahien
M
Back
Top Bottom