Hello,
I’m communicating a ControlLogix 5000 with a Yaskawa A1000 drive, via a Ethernet 1756en2tr module.
I installed the drive interface as a Generic Ethernet Module in my network, on the Studio5000 enviroment.
Produced and consumed assemblies are working fine, but I cant have acess to any information about the status of the drive in the network. My goal is to see if the drive is able to recieve the messages from or send them to the PLC.
As a comparision, in a DeviceNet Network we can monitore if a device is able to communicate via node check.
I’m communicating a ControlLogix 5000 with a Yaskawa A1000 drive, via a Ethernet 1756en2tr module.
I installed the drive interface as a Generic Ethernet Module in my network, on the Studio5000 enviroment.
Produced and consumed assemblies are working fine, but I cant have acess to any information about the status of the drive in the network. My goal is to see if the drive is able to recieve the messages from or send them to the PLC.
As a comparision, in a DeviceNet Network we can monitore if a device is able to communicate via node check.
Last edited: