Hi All,
I need to change the IP address in a Maple Systems HMI to put it on a SCADA network. I know how to change it on the HMI itself through the System Setting.
My question is.. To change the IP address of the PLC in the project, can I use the EZWarePlus "Demo" version or do I need to spend $75 and buy the full version software?
Thanks
Robert
I need to change the IP address in a Maple Systems HMI to put it on a SCADA network. I know how to change it on the HMI itself through the System Setting.
My question is.. To change the IP address of the PLC in the project, can I use the EZWarePlus "Demo" version or do I need to spend $75 and buy the full version software?
Thanks
Robert