Hello all,
I have a couple 1734-AENTR/C modules (revision 6.012) that are connected to a 1756-L73S (Revision 32.011). I have checked the compatibility and they don't show any issues.
The AENTR chassis has a 1734-IB8S, 1734-CTM and a 1734-OB8.
I have setup the AENTR with the proper IP address and chassis size (4) in the I/O tree and it matches what is in the web browser.
My issue is, when powered up the point bus status LED are flashing red. When I remove the CTM module and adjust the chassis size from 4 to 3 and move the OB8 from slot 3 to slot 2, it works fine.
Has anyone seen this? Any suggestions on how to fix this? Ideally we would like to have the spare slot between the safety card and the output card.
Thanks,
Scott
I have a couple 1734-AENTR/C modules (revision 6.012) that are connected to a 1756-L73S (Revision 32.011). I have checked the compatibility and they don't show any issues.
The AENTR chassis has a 1734-IB8S, 1734-CTM and a 1734-OB8.
I have setup the AENTR with the proper IP address and chassis size (4) in the I/O tree and it matches what is in the web browser.
My issue is, when powered up the point bus status LED are flashing red. When I remove the CTM module and adjust the chassis size from 4 to 3 and move the OB8 from slot 3 to slot 2, it works fine.
Has anyone seen this? Any suggestions on how to fix this? Ideally we would like to have the spare slot between the safety card and the output card.
Thanks,
Scott